See Turning on ICE for more information.ĭetects whether a server in the network is trying to relay mediaĭetermines the encryption policy for the account. You can use Relay if you are deploying Jabber for iPad in environments where most other devices do not understand ICE. Relay-the address of the TURN relay server.Rflx-the corporate public IP address seen from outside of the organization's network (public IP). if the remote side does not understand ICE.Among the mechanisms used are H.264-specific error recovery techniques, feedback from decoders, and forward error correction (FEC).īoth call participants must be using devices that support ClearPath for it to take effect. Bandwidth probing also requires these settings to be provisioned:ĬlearPath is a Cisco TelePresence solution that minimizes the negative effects of packet loss in a non-optimal network. The provisioned time is split into 256 KB/s intervals up to the maximum provisioned bandwidth. This option determines the duration of the probing in seconds: You cannot assign a template directly to an individual user.Īfter a user signs in to Jabber for iPad, the application probes the TURN relay server for bandwidth quality between the app and TURN server. The term "template schema" is used in TMSPE while the term "template" is used in TMS Agent Legacy.Īdd these server addresses, in addition to any other necessary settings, in the template:Īssign the template to the appropriate groups of users.Īny template you assign to a group is inherited by all users in the group, all subgroups, and all users in subgroups. Upload the template or template schema in TMS. ĭownload the template to your local server from. If you are using the TMS Provisioning Extension (TMSPE), included in TMS versions 13.2 and later, see the Cisco TelePresence Management Suite Provisioning Extension Deployment Guide at.If you are using the TMS Agent Legacy, included in TMS versions 13.2 and earlier, see the Cisco TelePresence Management Suite Agent Legacy Deployment Guide at.After you download the template and upload it in TMS, you can then set up the template and assign it to groups of users.įor detailed instructions about each of the steps in the procedure, consult the appropriate documentation: Jabber for iPad requires a specific template-an XML file containing all the possible settings supported by the application. Setup for TelePresence Video Communication Server Specifying maximum time for registration refresh.About Binary Floor Control Protocol (BFCP).Setting up provisioning template and assigning it to users.Setup for TelePresence Video Communication Server.
0 Comments
Leave a Reply. |